![]() You may stil have to run Universal Restore on your deployed image to generalize the drivers to allow Windows to boot after that, but if no XP drivers are available from the manufacturer for this new HP sytem, you may still be out of luck for hardware support if drivers are not available. In some bios, UEFI is the only possible method to boot now and CSM/legacy is not allowed or supported. In some systems that allow both, you still need to esnure that the boot order has UEFI/legacy first. In some bios, you have to specifically pick UEFI or Legacy mode only. In order to do that you would need to configure the bios so that secure boot is off and that csm/legacy mode is enabled as well. HOWEVER, I'd assume that your original XP system was installed as bios/legacy/csm in your WIM though anyway and not as UEFI since XP came out before UEFI did? If so, you need to be booting the toshiba system in bios/legacy/csm mode as well. Otherwise, you can try running universal restore on the system to see if it will at least boot. If there are no manufacturer drivers available, you may be out of luck. Cloning makes an exact copy of your old system drive. You can recover them quickly in the event of any disaster. It assures that all your important data, including photos, videos, music, documents and applications, are fully protected. The stop code in UEFI mode suggests that XP may not be compatible with your newer system hardware. Acronis True Image WD Edition helps to completely clone your current system drive onto your new WD hard drive. You'd have to install drivers after running Universal Restore though, but you can add drivers with Universal Restore as well. The thing that may be useful with Acronis in this situation is "Universal Restore" that can generalize drivers for any image to make different hardware bootable with the same image. Dism /Image:C:\test\offline /Add-Driver /Driver:C:\drivers\mydriver.inf /ForceUnsigned /Recurse Microsoft has a tool to do this for different SATA modes already that you can install if you need this to be a permanent change in your restored image.Īlternatively, you can add the Toshiba drivers into your WinPE as well., but may not help if it is BSOD becuase of the difference in bios sata mode ![]() If so, you could just temporarily change it in the bios, run your WinPE, then change it back in the bios again. If so, it may just be the SATA mode selected in the bios. What's the BSOD it's throwing (STOP 0x0000007B INACCESSABLE_BOOT_DEVICE?).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |